5.5.1 Configuring Advanced Internet Connection Setup
To edit your P-660HWP-D1's advanced WAN settings, click the Advanced Setup button in
the Internet Connection screen. The screen appears as shown.
Figure 40 Advanced Internet Connection Setup
The following table describes the labels in this screen.
Table 21 Advanced Internet Connection Setup
LABEL
RIP & Multicast
Setup
RIP Direction
RIP Version
Multicast
ATM QoS
ATM QoS Type
Peak Cell Rate
Sustain Cell Rate The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can be
P-660HWP-D1 User's Guide
DESCRIPTION
Select the RIP direction from None, Both, In Only and Out Only.
Select the RIP version from RIP-1, RIP-2B and RIP-2M.
IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to
establish membership in a multicast group. The P-660HWP-D1 supports both
IGMP version 1 (IGMP-v1) and IGMP-v2. Select None to disable it.
Select CBR (Continuous Bit Rate) to specify fixed (always-on) bandwidth for voice
or data traffic. Select UBR (Unspecified Bit Rate) for applications that are non-time
sensitive, such as e-mail. Select VBR-nRT (Variable Bit Rate-non Real Time) or
VBR-RT (Variable Bit Rate-Real Time) for bursty traffic and bandwidth sharing with
other applications.
Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find the Peak Cell
Rate (PCR). This is the maximum rate at which the sender can send cells. Type the
PCR here.
transmitted. Type the SCR, which must be less than the PCR. Note that system
default is 0 cells/sec.
Chapter 5 WAN Setup
81