Configuring Advanced Internet Connection Setup - ZyXEL Communications P660HW-DX V2 - V3.40 User Manual

Chapter 5 WAN Setup
Table 20 Internet Connection (continued)
LABEL
VPI
VCI
IP Address
Obtain an IP
Address
Automatically
Static IP Address
IP Address
Subnet Mask
(ENET ENCAP
encapsulation only)
Gateway IP address
(ENET ENCAP
encapsulation only)
Connection
(PPPoA and PPPoE
encapsulation only)
Nailed-Up
Connection
Connect on
Demand
Max Idle Timeout
Apply
Cancel
Advanced Setup

5.5.1 Configuring Advanced Internet Connection Setup

To edit your ZyXEL Device's advanced WAN settings, click the Advanced Setup button in
the Internet Connection screen. The screen appears as shown.
82
DESCRIPTION
The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local
management of ATM traffic). Enter the VCI assigned to you.
This option is available if you select Routing in the Mode field.
Select this if you get a dynamic IP address from your Internet Service Provider
(ISP). A dynamic IP address is not fixed; your ISP assigns you a different one
each time you connect to the Internet.
This option is not available if you select RFC 1483 in the Encapsulation field.
Select this if your ISP gave you a fixed IP address. Enter the IP address you
were given in the IP Address field.
If your ISP gave you an IP address to use, enter it here.
Enter a subnet mask in dotted decimal notation.
Refer to the appendices to calculate a subnet mask If you are implementing
subnetting.
You must specify a gateway IP address (supplied by your ISP) when you select
ENET ENCAP in the Encapsulation field
Select Nailed-Up Connection when you want your connection up all the time.
The ZyXEL Device will try to bring up the connection automatically if it is
disconnected.
Select Connect on Demand when you don't want the connection up all the time
and specify an idle time-out in the Max Idle Timeout field.
Specify an idle time-out in the Max Idle Timeout field when you select Connect
on Demand. The default setting is 0, which means the Internet session will not
timeout.
Click Apply to save the changes.
Click Cancel to begin configuring this screen afresh.
Click this button to display the Advanced Internet Connection Setup screen
and edit more details of your WAN setup.
P-660HW-Dx v2 User's Guide