Table 28 Wan Dial Backup Modem Setup - ZyXEL Communications P-662H-61 User Manual

P-662h series 802.11g adsl2+ 4-port security gateway
Hide thumbs Also See for P-662H-61:
Table of Contents

Advertisement

Chapter 5 WAN Setup
The following table describes the labels in this screen.

Table 28 WAN Dial Backup Modem Setup

LABEL
AT Command
Strings
Dial
Drop
Answer
Drop DTR When
Hang Up
AT Response
Strings
CLID
Called ID
Speed
Call Control
Dial Timeout
Retry Count
Retry Interval
Drop Timeout
Call Back Delay
Back
Apply
Cancel
100
DESCRIPTION
Type the AT Command string to make a call. Example: atdt
Type the AT Command string to drop a call. "~" represents a one second wait, for
example, "~~+++~~ath" can be used if your modem has a slow response time.
Type the AT Command string to answer a call. Example: ata
Select this check box to have the ZyXEL Device drop the DTR (Data Terminal
Ready) signal after the "AT Command String: Drop" is sent out.
Type the keyword that precedes the CLID (Calling Line Identification) in the AT
response string. This lets the ZyXEL Device capture the CLID in the AT response
string that comes from the WAN device. CLID is required for CLID authentication.
Example: NMBR
Type the keyword preceding the dialed number.
Type the keyword preceding the connection speed. Example: CONNECT
Type a number of seconds for the ZyXEL Device to try to set up an outgoing call
before timing out (stopping). Example: 60
Type a number of times for the ZyXEL Device to retry a busy or no-answer phone
number before blacklisting the number. Example: 0
Type a number of seconds for the ZyXEL Device to wait before trying another call
after a call has failed. This applies before a phone number is blacklisted. Example:
10
Type the number of seconds for the ZyXEL Device to wait before dropping the DTR
signal if it does not receive a positive disconnect confirmation. Example: 20
Type a number of seconds for the ZyXEL Device to wait between dropping a
callback request call and dialing the corresponding callback call. Example: 15
Click Back to return to the previous screen.
Click Apply to save the changes.
Click Cancel to begin configuring this screen afresh.
P-662H/HW-D Series User's Guide

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents