Port Forwarding Rule Edit; Figure 86 Port Forwarding Rule Setup; Table 54 Port Forwarding Rule Setup - ZyXEL Communications P-662H-61 User Manual

Chapter 9 Network Address Translation (NAT) Screens
Table 53 NAT Port Forwarding
LABEL
#
Active
Service Name
Start Port
End Port
Server IP
Address
Modify
Apply
Cancel

9.5.1 Port Forwarding Rule Edit

Use this screen to edit a port forwarding rule, click the rule's edit icon in the Port Forwarding
screen to display the screen shown next.

Figure 86 Port Forwarding Rule Setup

The following table describes the fields in this screen.

Table 54 Port Forwarding Rule Setup

LABEL
Active
Service Name
Start Port
End Port
148
DESCRIPTION
This is the rule index number (read-only).
Click this check box to enable the rule.
This is a service's name.
This is the first port number that identifies a service.
This is the last port number that identifies a service.
This is the server's IP address.
Click the Edit icon to go to the screen where you can edit the port forwarding rule.
Click the Delete icon to delete an existing port forwarding rule. Note that
subsequent rules move up by one when you take this action.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to return to the previous configuration.
DESCRIPTION
Click this check box to enable the rule.
Enter a name to identify this port-forwarding rule.
Enter a port number in this field.
To forward only one port, enter the port number again in the End Port field.
To forward a series of ports, enter the start port number here and the end port
number in the End Port field.
Enter a port number in this field.
To forward only one port, enter the port number again in the Start Port field above
and then enter it again in this field.
To forward a series of ports, enter the last port number in a series that begins with
the port number in the Start Port field above.
P-662H/HW-D Series User's Guide