Figure 297 Displaying Log Categories Example; Figure 298 Displaying Log Parameters Example - ZyXEL Communications P-662H-61 User Manual

Appendix J Command Interpreter
Command Examples
This section provides some examples of commands you can use on the ZyXEL Device. This
list is intended as a general reference of examples. The commands available in your ZyXEL
Device may differ from the examples given here. See the other appendices for more examples.
Configuring What You Want the ZyXEL Device to Log
1 Use the
configure which logs the ZyXEL Device is to record.
2 Use

Figure 297 Displaying Log Categories Example

ras> sys logs category
8021x
error
javablocked
cdr
tcpreset
urlforward
3 Use
are available for the category.

Figure 298 Displaying Log Parameters Example

ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both] [0:don't show debug type/1:show debug
type]
4 Use
record.
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to
record only alerts for that category, and 3 to record both logs and alerts for that category.
Not every parameter is available with every category.
5 Use the
do this in order to record logs).
Displaying Logs
• Use the
log.
• Use the
log categories.
438
command to load the log setting buffer that allows you to
sys logs load
to view a list of the log categories.
sys logs category
access
icmp
mten
pki
traffic
wireless
sys logs category
followed by a log category and a parameter to decide what to
sys logs category
command to store the settings in the ZyXEL Device (you must
sys logs save
sys logs display
sys logs category display
attack display
ike ipsec
packetfilter ppp
tls remote
upnp urlblocked
followed by a log category to display the parameters that
command to show all of the logs in the ZyXEL Device's
command to show the log settings for all of the
P-662H/HW-D Series User's Guide