Base Unit Placement; Multiple Base Units - Doro 5055R Manual

English
Expanded System
Base Units Placement
If you wish to use several handsets with one base unit, you should make
sure that the base unit is placed "in the middle", to evenly divide the
base unit range among the handsets.
If you wish to use several base units to achieve an extended coverage
within a specifi c area, eg a large home or offi ce, a storage area, etc, then
it is important that the range of the base stations overlap. If not there
may be a reduced communication in certain areas where a handset has
no signal from the base units.

Multiple Base Units

By connecting several base units to the system, the useful range for
the handset can be expanded.. Registering multiple base units with the
handset will cause the handset to automatically connect to another base
if and when it loses contact with the current base unit Another practical
application could be to have one base station at home and one at work.
Then the same handset can be used in both places.
The handset remains in contact with its base unit until it goes out of
range. When this happens, the handset will begin to search for another
base from its list of registered base units. It is essential that the range
of the base units overlap, in order to achieve uninterrupted coverage.
The transfer from one base unit to another will then be automatic,
however, this will not occur while a call is in progress. If not, there may
be reduced communication in certain areas where the handsets have no
signal from the base units.
More about placement of the base units on the next page.
IMPORTANT!
Automatic switching between base units (handset handover) will not occur while a call
is in progress.
24 www.doro.com