TV sets, computer screens, telecom equipment, fans etc. This will minimize the risk of interference. Do not place the base unit in areas where it will be exposed to direct sunlight or other major heat sources. www.doro.com...
When the telephone is installed for the first time, the batteries must be charged for 24 hours before using the telephone. Use original batteries only. The guarantee does not cover any damage caused by incorrect use of batteries. Please dispose of any batteries in a responsible and environmentally friendly manner. www.doro.com...
This telephone supports the use of the mute function with a button on the headset cable. Please note! Immediately reduce the earpiece volume on the handset when connecting an optional headset. The performance of a non-original DORO headset cannot be guaranteed. www.doro.com...
Charging indicator. Key Lock Internal Call Base unit indicators 530 only: Light illuminated while charging; flashes during a call/registration. Only 540R: Light illuminated while charging. Light flashes during a call, registering and when ringing. Light illuminated when Answering machine on. www.doro.com...
1. Press and hold until the display shows 2. To deactivate the key lock press and hold again. Calls can still be received even if the key lock is active. When the call is finished the handset returns to locked mode. www.doro.com...
The switchover between speaker and microphone is automatic and dependent on the sound level of the incoming call and the microphone respectively. It is therefore essential that there are no loud noises in the immediate vicinity of the telephone, as this will disrupt the speaker function. www.doro.com...
Dialling using speed dial memories 1. Press 2. Enter the required memory location, 3. Press the displayed number will now be dialled. Erasing all speed dial numbers 1. Press and hold until P is displayed. º 2. Press 3. Press 4. Press º www.doro.com...
Messages Apart from showing phone numbers, the display can show: It is an International call or a call from a PBX (no information received). The list is empty. Time/date information not transmitted or received. www.doro.com...
Page 13
C for a few seconds while in standby mode. Please Note! In order for the network voice mail to operate, you must subscribe to this service and/or have it activated by your network operator. Contact your operator for more information. www.doro.com...
Press and hold to turn ringer back on. Ringer volume base unit (only DORO 540R) The base units ringer can be switched on or off. ■ 1. Press and hold for 10 seconds to switch the ringer off.
4. Press to save. º Turning the function on/off To switch this function on or off simply repeat the following sequence. 1. Press and hold until P is displayed on the handset. º 2. Press 3. Press to save. º www.doro.com...
An individual handset can be reset to the original factory default condition. 1. Press and hold until P is displayed on the handset. º 2. Press 3. Enter the units PIN number (0000 for this model). to save . 4. Press º www.doro.com...
Refer to the Registration chapter for more information. If you wish to use several handsets with one base unit, you should ensure that the base unit is centrally positioned in order to evenly divide the base units range among the handsets. www.doro.com...
Any additional handset can easily be de-registered from a base unit. 1. Simultaneously press and hold until you hear a beep. 2. Enter the units PIN number (0000 for this model). 3. When HS is shown in the display, enter the handset number you wish to delete. www.doro.com...
5. To connect all three parties in a conference call, on the original handset press and hold until stops flashing in the handset display. Press on either handset to terminate the conference call, the other handset can then continue the conversation with the external party. www.doro.com...
On or Off. When ON is selected ‘‘Answer on’’ and the outgoing message will be heard, and all incoming calls will be answered by the answering machine. In the OFF position will flash in the base unit display and calls will not be answered. www.doro.com...
ANN message will automatically be erased when a new one is recorded. Checking the Outgoing Message 1. Press . The current OGM/ANN message will be replayed. To revert to the original pre-recorded OGM message. 1. Press and release 2. While your current OGM message is playing press C. www.doro.com...
If on the other hand the machine answers after two rings new messages have been recorded. www.doro.com...
Page 23
Button Function Repeat/skip to previous. Skip to next message. ■ Stop playback. Erase current message. VOL +/- Increase or decrease the volume. Pause during playback (max. 60 seconds). The base unit display will show . Press again to continue. www.doro.com...
1. Press and hold until you hear a beep. 2. Speak clearly towards the top of the base unit and record your MEMO message. 3. Release to stop recording. 4. Memos can be replayed as with any ICM by pressing www.doro.com...
When the memory is full will flash in the base unit display and the answering machine will respond with a special message to allow remote playback and deletion of messages. www.doro.com...
If you have forgotten to turn the machine on, this can be done remotely. Remote options are described in full on page 27. 1. Dial the telephone number for the answering machine. The answer machine will answer after 10 rings. 2. The answering machine is now on. 3. Terminate the call. www.doro.com...
If the machine doesn’t respond correctly to the remote control commands, try pressing the telephone buttons for a longer or shorter time. In normal cases, the answering machine should react to tones approximately 0.5 – 1 seconds in length, but longer tones may be necessary in certain telephone networks. www.doro.com...
- Check that the charge contacts in the hand and base unit are clean. - Try connecting another telephone known to be in working order to the line socket. If that phone works, then it is likely that the equipment is faulty. www.doro.com...
Page 29
- Also try holding the buttons down longer, approximately 1 second per digit. If the telephone still does not work, contact Doro or the place of purchase. Don’t forget the receipt or copy of the invoice will be required for guarantee purposes.
9AM - 5PM Monday-Friday excluding Bank Holidays. Alternatively, E-mail on: tech@doro-uk.com You can contact us in writing: Consumer Support Group, Doro UK Ltd., 22 Walkers Road, North Moons Moat, Redditch, Worcestershire, B98 9HE, (regarding any Spares or Technical query), or Telephoning (Spares only): 01527 584377 Web site: www.doro-uk.com...
(As a matter of precaution, we recommend disconnecting the telephone during a thunderstorm). This guarantee does not affect your statutory rights. AUSTRALIA NEW ZEALAND DORO Australia Pty Ltd Atlas Gentech (NZ) Limited PO Box 6760 Private Bag 14927 Baulkham Hills BC NSW 2153...
If a charge for local calls is unacceptable, the “DIAL“ button should NOT be used for local calls. Only the 7 digits of the local number should be dialled from your telephone. DO NOT dial the area code digit or the “0“ prefix. www.doro.com...