Cisco SPA300 Series User Manual page 74

Using Advanced Phone Features
Using the Interactive Voice Response Menu on Cisco SPA501G
Cisco SPA300 and SPA500 Series IP Phones with Cisco Unified Communications UC320W
Typical options you might use are listed in the following table:
Number Option
100 Tells you if Dynamic Host Configuration Protocol (DHCP) is enabled.
110 Recites the IP address of the phone.
120 Recites the netmask of the phone.
130 Recites the gateway address.
140 Recites the MAC (hardware) address of the phone.
150 Recites the phone software version.
160 Recites the primary DNS server address.
170 Recites the HTTP port on which the web server listens. Defaults to
80.
180 Recites the IP multicast address.
220 Recites the method of call control (SIP or SPCP).
87778 Restore the phone's user settings to the default. (Clears all user
settings such as speed dials.) CAUTION: You should perform this
action only if requested by your phone administrator or other support
personnel.
Press
exit and begin the restore process.
732668 Reboot the phone. After entering
(R-E-B-O-O-T)
73738 Restores the phone to the factory default software and settings.
(R-E-S-E-T) CAUTION: You should perform this action only if requested by your
phone administrator or other support personnel.
Press
exit and begin the restore process.
to confirm, or to exit. If you chose to reset, hang up to
1
*
to confirm, or to exit. If you chose to reset, hang up to
1
*
# , hang up to begin rebooting.
3
74