Cisco VoIP IP SPA504G Setup & User Guide About This Guide This guide is intended to show you how to install your phone and describes how to use some of the basic functions and features. The features available on your phone depend on the type of system to which your phone is connected.
Installing Your IP Phone Use these procedures to install the phone and connect it to your network. STEP 1 Turn the phone body over to expose the ports on the back of the unit. CAUTION Do not insert a telephone line cord into the auxiliary port. STEP 2 Insert the long end of the phone cord into the handset port on the phone body that is marked with a phone symbol.
• Using a Wireless Connection—You can use a Cisco WBP54G Wireless-G Bridge with the IP phone to create a wireless connection between the phone and the network. See the WBP54G documentation on Cisco.com for more information (see the list of links at the end of this document).
Once you see a Cisco page you need to click the Admin Login button in the top right hand corner A new page will load and you will now see a lot more buttons appear. Once they do simply click on the Ext 1 button You will now be required to enter your Saco Technology VoIP account information.
Then you will need to enter your VoIP SIP/Account Number (In both sections below) and also your password. Then the last step is to then enter your VoIP SIP/Account Number again in the User ID field and to make sure Use Auth ID has yes selected as shown below. Now simply hit the submit all changes button at the bottom of the page and you phone will now save the new settings and reset.
Using the Call Features of the Cisco SPA504G Placing a Call There are 2 options available to place a call: Lift the handset and dial the number. (This method will take 5 seconds before it makes the call) Dial the number and press the ―dial‖...
Blind Transferring This feature allows you to transfer a call without speaking to the person you are transferring to. While on the call, press the ―xfer‖ key (this will place the caller on hold). Then simply Dial the VoIP extension you require if transferring to someone in the office or enter the mobile or landline number to which you want to transfer the call.
Do Not Disturb To enable Do Not Disturb hit the ―dnd‖ soft key To disable Do Not Disturb hit the ―-dnd‖ soft key Accessing Voice Mail Press You will then need to enter your SIP/Account Number followed by your password. Simply call *98 from your VoIP Phone and then enter your SIP/Account Number followed by your password.