Turning On And Off The Auto Power Switch - Fujitsu ETERNUS DX60 S2 User Manual

Chapter 2 Standard Operations

2.4 Turning On and Off the AUTO POWER Switch

■
Procedure for removing the front cover
Remove the front cover in the following order.
Procedure
1
2.4 Turning On and Off the AUTO POWER Switch
This section explains how to enable the AC automatic linkage mode by turning the AUTO
POWER switch of the controller enclosure to "ON".
When AC automatic linkage mode is enabled, the ETERNUS DX Disk storage system is auto-
matically turned on when the power supply recovers after a power failure.
When the AUTO POWER switch of the controller enclosure is set to "OFF", the AC automatic
linkage mode is disabled.
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
By holding the tab of the front cover, pull the cover toward you to remove it.
CAUTION
• When removing the right side of the front cover, support its left
side with your left hand, to prevent it from coming loose and
falling.
Copyright 2013 FUJITSU LIMITED
Do
Tab
39
End of procedure
P3AM-5512-05ENZ0