Advertisement
A
urorA
CROSSBAR mOUNTINg BRACKET INSTALLATION
proceed with installation as follows:
Step 1. Install the 4 isolators into the bottom of the crossbar
mounting bracket.
Step 1a. Route the wires from the ceiling outlet box through
the crossbar mounting bracket center hole. Attach the bracket,
with ground wire down, to the 'Approved For Ceiling Fan
Installation' ceiling fixture outlet box with the outlet box
mounting hardware.
Tighten the screws firmly, being careful not to bend the
bracket by over tightening.
CAUTION: To reduce the risk of
personal injury, use only the
mounting hardware provided with
the approved outlet box to install
the crossbar mounting bracket.
NOTE: This step is required only under two conditions: If
the fan weighs 36 lbs. or more or if the existing ceiling
fixture outlet box needs to be modified for a ceiling
fan application (for example, if the house is not new
construction and you are replacing an existing light fixture).
We recommend that the ceiling box be of sufficient capacity
to support the weight of the fan and light fixture under any
conditions. If in doubt whether you need to install the lag
screw, consult a qualified electrician.
Step 2. With the large washer attached, pass the lag screw
through the center hole of the ceiling plate and screw into
the guide hole. Tighten until the outlet box is mounted
firmly to the beam. This box must be secured to the ceiling
firmly.
CANOpY
HATCH
4
II
™
Lag Screw InStaLLatIon
CANOpY HARDWARE
CANOpY
CEILINg FAN
AppROVED
WIRINg BOX
FLAT
WASHER
AppROVED
OUTLET BOX
HARDWARE
CANOpY SCREW (4)
CANOpY LOCK WASHER (4)
CEILINg
WIRINg
CROSSBAR
mOUNTINg
BRACKET
gREEN
gROUND
WIRE
Advertisement
