Advertisement
Please refer to this troubleshooting guide before requesting service or contacting your dealer for assistance.
pROBlEm
Fan will not start
Fan wobbles or shakes excessively
Fan is noisy during operation
Fan does not run on low speed
Battery life is short
Light works, but fan does not work
Fan and light run only on full speed
Fan is missing one speed
Fan does not change speed, but light works
Reverse does not work
Fan starts working by itself
Fan operates only when transmitter is close
Fan works, but light does not dim
Fan works, but light does not work
TROUBlESHOOTIng TIpS
pOSSIBlE REmEDIES
• Check the main circuit fuses, circuit breakers, and wall switch position. Check all wire
connections. Make sure the power is turned off during this inspection.
• The 9-pin connector is not making good contact. Check the 9-pin connector in the receiver
mounted in the switch housing
• The battery is weak. Install a fresh battery.
• The fan receiver is defective. Replace fan receiver.
• Check the frequency setting: Turn the power off at the circuit breaker, only for the fan
that is not functioning. Check that the jumper switches match in both the receiver and
the transmitter.
• Be sure the canopy pin is set properly into the slot on the ball.
• Check that the bladeholders have not been bent during installation and the blades are
balanced.
• The hanger bracket and/or ceiling outlet are attached too loosely. Make sure the hanger
bracket is attached tightly to the ceiling outlet box and the downrod assembly is secured
firmly.
• The downrod is attached to downrod base too loosely. Make sure all the screws are securely
tightened.
• Check and tighten the light fixture retaining screws, glass shade screws, and/or
lightbulb(s).
• Tighten the canopy screws and mounting plate assembly. Make sure the wire nuts inside
the canopy and switch housing are not touching the metal parts and that they have not
fallen off the wire splices. Tighten as necessary.
• Tighten the blade holders to the flywheel (or direct drive motor) and the blades to the
bladeholder screws.
• Make sure all screws in the motor housing are snug but not overly tight.
• If fan is new, it may need to be "broken in." Run at high speed for several days.
• Replace with alkaline batteries.
• The fan wires are not connected properly.
• The fan receiver is defective. Replace fan receiver.
• The fan receiver is defective. Replace fan receiver.
• The fan receiver is defective. Replace fan receiver.
• The fan receiver is defective. Replace fan receiver.
• There is frequency interference. Change frequency.
• Check that antenna wire is not touching metal plate.
• The fan receiver is defective. Replace fan receiver.
• The fan receiver is defective. Replace fan receiver.
• The light socket is broken. Replace socket.
• A lightbulb is defective. Replace lightbulb.
11
Advertisement
