Download Print this page

Advertisement

Quick Links

INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
mOUNTINg RECOmmENDATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
FAN INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
CONTROL FEATURES:
3-SpEED OpERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
versa•touch operation
TROUBLESHOOTINg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Safety and the proper operation of your Casablanca fan both require a thorough knowledge of the product
and proper installation; therefore, before attempting to install and operate your Casablanca fan, read this
owner's manual completely and carefully. Retain this manual for future reference.
cauTion: To avoid possible electrical shock, make certain that electricity is turned off at
the circuit breaker or fuse box before attempting any installation procedure.
• All wiring must be in accordance with the National Electric Code ANSI/NFPA 70-2005 and the appropriate local electrical
codes. The National Electric Code requires proper grounding as a precaution against electrical shock. A qualified electri-
cian should be consulted if you are unsure.
• This fan is designed to be installed on an existing electrical outlet box. The outlet box must be UL Listed for ceiling fan
installations, if it is not, a new box must be installed. Casablanca extension poles are available for sloped or high ceiling
installations.
• This ceiling fan requires a grounded electrical supply of 120 VAC, 60 Hz and a minimum 15 amp circuit. The maximum
current requirement for the fan with light fixture is 3.8 amps. The fan uses about 1 amp or 100 watts. Maximum light
current is 2.8 amps or 340 watts of lighting.
• Where wire nuts are employed, be sure all bare wires are within the connectors. When installing the canopy hatch, make
sure all wires are within the canopy and that no wires are being pinched.
use only genuine Casablanca blades, light fixtures, and accessories.
• The blades in each pack are matched for
equal weight to assure smooth fan operation.
If more than one fan is being installed, be
careful not to mix blades from different
cartons.
• Inspect the contents of your carton for
possible shipping or handling damage and
report any such damage directly to your
authorized Casablanca dealer.
• It is always a good idea to have an assistant
to help with the installation.
• When cleaning, painting, or working near
your fan, be very careful of the fan and
blades. Always turn the power OFF to the
ceiling fan before servicing it, working on
it, or replacing light bulbs.
• Never insert anything into the path of the
fan blades while the fan is in operation.
• Never install a fan over a pool or spa.
• Never operate a fan that has been damaged in
any way. Contact Casablanca Fan Company by
calling toll free 1-888-227-2178, or contact
your local authorized Casablanca dealer for
assistance in obtaining service.
CONTENTS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
READ AND SAVE THESE INSTRUCTIONS

SAFETY FIRST

BEFORE YOU START
For best performance and for your warranty to be valid,
SAFE USE
FUSE BOX
(remove fuse for The
circuiT you will be
working on)
CIRCUIT BREAKER
(Trip breaker for The
circuiT you will be
working on)
PN 4243210
18"
42UxxLM
70"
84"
1

Advertisement

loading

Summary of Contents for Casablanca AURORA II

  • Page 1: Safety First

    • This fan is designed to be installed on an existing electrical outlet box. The outlet box must be UL Listed for ceiling fan installations, if it is not, a new box must be installed. Casablanca extension poles are available for sloped or high ceiling installations.
  • Page 2 ™ urorA mOUNTINg RECOmmENDATIONS Before mounting your Casablanca fan, read the following helpful recommendations. The location of the fan, air circulation, and fan size are all important factors to consider before installation. Location Ceiling fans have practical uses in almost every room in your home. We suggest you follow these mount- ing recommendations as you decide where to install your Casablanca fan.
  • Page 3: Important Safety Information

    If you do not have an existing fixture located where you wish After turning the power OFF at its source (either circuit to place your Casablanca fan, an approved ceiling fixture breaker or fuse box), lower the old fixture and disconnect outlet box must be installed and wired.
  • Page 4 ™ urorA CROSSBAR mOUNTINg BRACKET INSTALLATION proceed with installation as follows: Step 1. Install the 4 isolators into the bottom of the crossbar mounting bracket. Step 1a. Route the wires from the ceiling outlet box through the crossbar mounting bracket center hole. Attach the bracket, with ground wire down, to the ‘Approved For Ceiling Fan Installation’...
  • Page 5 ™ urorA CANOpY INSTALLATION Step 3. Attach the canopy to the crossbar mount- ing bracket with three of the 8-32 x 2 long canopy screws and canopy lock washers. Hand tighten until snug against the ceiling. note: On sloped ceilings, align the CROSSBAR mOUNTINg canopy opening towards the top or BRACKET INSTALLED...
  • Page 6 ™ urorA CANOpY HATCH INSTALLATION Step 6. Tuck the wires into the canopy with the wire nuts pointed upwards, so that the WHITE and BLACK wires are on opposite sides of the canopy and all wires CANOpY CANOpY are clear of the canopy opening. HATCH COVER RINg...
  • Page 7 ™ urorA BLADE INSTALLATION Step 11. Insert 1 grommet in each of the 4 holes in all blades. SHOULDER SCREW Step 11a. Attach each blade to a blade (4 pER BLADE) BLADE holder securing it with the four blade gROmmET screws provided.
  • Page 8 ™ urorA INSTALLINg THE SWITCH HOUSINg Step 14. Locate the three (3) 8-32 X “ screws provided. Step 15. Line up the three threaded holes in the rim of the switch housing with the three clearance holes in the switch housing mount. Carefully slide the switch housing into the mount so that the threaded...
  • Page 9 ™ urorA VERSA•TOUCH2™ COnTROl InSTAllATIOn Versa•Touch2™ hardware (not to scale) Wood Screw Screw Drywall Screw 6-32 X " 6-32 X 1" 12v Battery Anchor 1" (2) 6-32 (2) W-72 W-72 Control Holder Control COnTROl BRACkET InSTAllATIOn SAFETY FIRST: To reduce the risk of electrical shock, this fan must be installed with an isolating wall control/ switch.
  • Page 10 ™ urorA REmOTE OpERATIOn Fan Control To start the fan. Press the selected speed button to run the fan at the desired speed. Send Signal LIght LOW=Low speed MED=Medium speed HIGH=High speed To turn off the fan, press the FAN OFF button. airflow direction To reverse the airflow, press the reVerse button.
  • Page 11 TROUBlESHOOTIng TIpS Please refer to this troubleshooting guide before requesting service or contacting your dealer for assistance. pROBlEm pOSSIBlE REmEDIES Fan will not start • Check the main circuit fuses, circuit breakers, and wall switch position. Check all wire connections. Make sure the power is turned off during this inspection. •...
  • Page 12 pRODUCT SpECIFICATIOnS 188mm x 20mm Direct Drive ™ Model Name: Aurora™ II Motor: Model Number: 42UxxLM Blade Span: 53" Blade Iron Pitch: 14° No. of Blades: Dimensions: A = 12" Versa•Touch2 ® W-72 Technology: B = 12.75" C = 3" D = 12.5"...