Advertisement
A
urorA
Step 6. Tuck the wires into the canopy
with the wire nuts pointed upwards, so
that the WHITE and BLACK wires are on
opposite sides of the canopy and all wires
are clear of the canopy opening.
Step 7. Install canopy hatch with the
last canopy screw and lock washer. To
do this, tilt the fan body away from the
hatch opening.
Tighten the screws firmly by hand only,
Step 8. Straighten the fan, then check
to ensure that there is no movement be-
tween the canopy and ceiling or Hang-Tru
ball and top support shaft.
Step 9. Slide the Canopy Cover Ring up
to the canopy and insert the pins into the
holes in the canopy to lock into place.
INSTALLINg THE BLADE/BLADE HOLDER TO FAN mOTOR
Step 10. To reach the blade holder mounting
holes in the fan motor the switch housing mount
must be temporarily removed.
Take out the three 8-32 X
3/8
securing the switch housing mount and re-
move. Put the three (3) screws and switch
housing mount aside for the moment, they
will be replaced in Step 13 after the blades
are installed.
note: Versa•Touch models
will have only a wire nut
capping the black and
white wires coming out of
the fan motor.
BLADE TO BLADE HOLDER INSTALLATION
SHOULDER SCREW
(4 pER BLADE)
gROmmET
(4 pER BLADE)
6
II
™
CANOpY HATCH INSTALLATION
note: Write down the
Serial Number and the
model number for future
reference.
pREpARATION
" shoulder screws
BLADE & BLADE HOLDER HARDWARE
CANOpY
HATCH
LOCK
WASHER
CANOpY
SCREW
SWITCH HOUSINg mOUNT
SHOULDER SCREW
8-32 X
" (3)
3/8
BLADE
HOLDER
CANOpY
COVER
RINg
TILT THE
FAN TO
INSTALL
LAST
CANOpY
SCREW
SWITCH
HOUSINg
mOUNT
BLADE HOLDER
SCREW
(2 pER BLADE)
Advertisement
