Download Print this page

Advertisement

INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
mOUNTINg RECOmmENDATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
FAN INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
CONTROL FEATURES:
inteli•touch operation
inteli•touch troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
3-speed operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . 11
3-speed troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13
product specifications . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14
Safety and the proper operation of your Casablanca fan both require a thorough knowledge of the
product and proper installation; therefore, before attempting to install and operate your Casablanca
fan, read this owner's manual completely and carefully. Retain this manual for future reference.
cauTion: To avoid possible electrical shock, make certain that electricity is turned off at
the circuit breaker or fuse box before attempting any installation procedure.
• All wiring must be in accordance with the National Electric Code ANSI/NFPA 70-1993 and the appropriate local electrical
codes. The National Electric Code requires proper grounding as a precaution against electrical shock. A qualified electri-
cian should be consulted if you are unsure.
• This fan is designed to be installed on an existing electrical outlet box. The outlet box must be UL Listed for ceiling fan
installations, if it is not, a new box must be installed. Casablanca extension poles are available for sloped or high ceiling
installations.
• This ceiling fan requires a grounded electrical supply of 120 VAC, 60 Hz and a minimum 15 amp circuit. The maximum
current requirement for the fan with light fixture is 3.8 amps. The fan uses about 1 amp or 100 watts. Maximum light
current is 2.8 amps or 340 watts of lighting.
• Where wire nuts are employed, be sure all bare wires are within the connectors. When installing the canopy hatch, make
sure all wires are within the canopy and that no wires are being pinched.
use only genuine Casablanca blades, light fixtures, and accessories.
• The blades in each pack are matched for
equal weight to assure smooth fan operation.
If more than one fan is being installed, be
careful not to mix blades from different
cartons.
• Inspect the contents of your carton for
possible shipping or handling damage and
report any such damage directly to your
authorized Casablanca dealer.
• It is always a good idea to have an assistant
to help with the installation.
• When cleaning, painting, or working near
your fan, be very careful of the fan and
blades. Always turn the power OFF to the
ceiling fan before servicing it, working on
it, or replacing light bulbs.
• Never insert anything into the path of the
fan blades while the fan is in operation.
• Never install a fan over a pool or spa.
• Never operate a fan that has been damaged in
any way. Contact Casablanca Fan Company by
calling 1-888-227-2178, or contact your local
authorized Casablanca dealer for assistance
in obtaining service.
CONTENTS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
read and saVe these instructions
BEFORE YOU START
For best performance and for your warranty to be valid,
NOTES
FUSE BOX
(remove fuse for The
circuiT you will be
working on)
CIRCUIT BREAKER
(Trip breaker for The
circuiT you will be
working on)
pn 6743001
18"
at1008
70"
84"
1

Advertisement

loading

Summary of Contents for Casablanca at1008

  • Page 1 • Never install a fan over a pool or spa. • Never operate a fan that has been damaged in any way. Contact Casablanca Fan Company by calling 1-888-227-2178, or contact your local authorized Casablanca dealer for assistance in obtaining service.
  • Page 2 MOUNTING RECOMMENDATIONS Before mounting your Casablanca fan, read the following helpful recommendations. The location of the fan, air circulation, and fan size are all important factors to consider before installation. Location Ceiling fans have practical uses in almost every room in your home. We suggest you follow these mounting recommendations as you decide where to install your Casablanca fan.
  • Page 3: Important Safety Information

    ® entura INSTALLATION INSTRUCTIONS Unpacking: Before assembling and installing your ceiling fan, noTe: Only one set of blade holders is supplied. Depend- remove all parts from the shipping cartons and check them ing on the fan model and series they will be either the against the parts listed here.
  • Page 4 CROSSBAR MOUNTING BRACkET INSTALLATION proceed with installation as follows: CEILINg FAN Step 1. Route the wires from the ceiling outlet box through approVed wIRINg BOX the crossbar mounting bracket center hole. Attach the bracket, with ground wire and ridges down, to the ceiling fixture outlet box with the mounting hardware included with the outlet box.
  • Page 5 ® entura HANGING THE FAN Step 3. To hang the fan body in the canopy, hold the fan body firmly and insert the ball into the canopy open- ing. Check that no wires were pinched. Rotate the fan body until the slot in the nylon ball fits into the pin opposite the capped canopy opening.
  • Page 6 BLADE HOLDERS & HARDWARE blade holder screW fiber Washer (not BLADE SCREw (2 per blade) included in daMp (3 per blade) STANDARD STyLE LOCATION FANS) STANDARD STYLE BLADE HOLDER & BLADE Step 8. Standard Style BLADE SCREw Attach the blades to the blade blade holder (3 per blade) holders with the three blade...
  • Page 7 Inteli•Touch ® INTELI•TOUCH INSTALLING THE W-32 WALL CONTROL The wall control installs in the same manner as an ordinary light switch, using an existing junction box and wiring. This controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the following precautions must be observed: 1.
  • Page 8: Automatic Demonstration Program

    Inteli•Touch ® INTELI•TOUCH OPERATION POWER The POWER button is normally left in the on position. Always turn the power off during cleaning or servicing the fan and during thunderstorms. It is also used to exit or enter additional programs. POWER must be left on to retain a previously set fan speed or light level.
  • Page 9 Inteli•Touch ® INTELI•TOUCH OPERATION LIGHT -MINDER PROGRAM The Light-Minder program automatically turns OFF the fan mounted lights after two hours. To enter the Light-Minder Program: 1. Turn the POWEROFF for at least three seconds. POWER 2. Turn the POWER 3. Immediately operate the buttons in the following sequence: LIGHT LIGHT 4.
  • Page 10 Inteli•Touch ® TROUBLESHOOTING Before Requesting Service: Please follow this troubleshooting guide be- fore contacting your dealer for assistance. Caring for Finishes: For cleaning, a soft brush or lint-free cloth Never Lubricate this Fan! should be used to prevent scratching the finish. A vacuum cleaner The precision motor at the heart of your Casablanca fan features brush nozzle can remove heavier dust.
  • Page 11 3-SPEED ♦ OPERATION Pull-chain switches on the fan control the fan and lights. Using the fan control pull-chain switch: Fan off at start. optional light fan & speed con- pull chain TROL First pull: fan ON, low speed sWitch pull chain sWitch Second pull: medium speed Third pull: high speed Fourth pull: fan OFF...
  • Page 12 OPTIONAL 3-SPEED W-40 WALL CONTROL • The W-40 allows the choice of four (4) different speed settings. • No light fixture is used. • Set the FAN pull chain switch to the HIGH speed setting. • No changes in household or fan wiring are required.
  • Page 13 TROUBLESHOOTING before requesting service: please follow this troubleshooting guide before contacting your dealer for assistance. Caring for Finishes: For cleaning, a soft brush or lint-free cloth Never Lubricate this Fan! should be used to prevent scratching the finish. A vacuum cleaner The precision motor at the heart of your Casablanca fan features brush nozzle can remove heavier dust.
  • Page 14 PRODUCT SPECIFICATIONS XLP-2000 ® Model Name: Ventura® Motor: Model Number: 67XXD/T Blade Span: 42" or 50" Blade Iron Pitch: 16° No. of Blades: Dimensions: A = 11" Technology: 3-Speed B = 12.5" Inteli•Touch® W-32 C = 3" NOTE: Dimension B includes light fixture D = 10.3"...