Advertisement
Step 3. Attach the canopy to the crossbar mount-
ing bracket with three of the 8-32 x 2
canopy screws and canopy lock washers. Hand
tighten until snug against the ceiling.
note: On sloped ceilings, align the
canopy opening towards the top or
room peak.
Step 4. To hang the fan body in the can-
opy, hold the fan body firmly and insert
the nylon ball into the canopy opening.
Check that no wires were pinched. Rotate
the fan body until the slot in the nylon
ball fits into the pin opposite the canopy
opening.
Step 5. Attach the fan wires to the ceiling fixture outlet box
wiring by twisting the bare ends of the wires together and
then securing with a wire nut. Test that the connection is
secure by pulling on the wire nut. Connect in this order:
step 5a. versa•touch connections
• GREEN leads from mounting plate and fan to GROUND
conductor of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling
fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to BLACK power wire in ceiling
outlet box. Secure with wire nut.
CANOpY INSTALLATION
long
1
/
4
HANgINg THE FAN
SLOT
CANOpY ELECTRICAL CONNECTIONS
A
urorA
CROSSBAR mOUNTINg
BRACKET INSTALLED
CANOpY LOCK
WASHERS
CANOpY
SCREWS
BALL
note: Fan weighs 26.4 lbs.
WIRE NUT
2 BLACK WIRES
3 gREEN WIRES
2 WHITE WIRES
II
™
CANOpY
pIN
versa•touch
CONNECTIONS
5
Advertisement
