Cisco TelePresence SX20 Codec Reference Manual page 93

Cisco TelePresence SX20 Codec
Contents Introduction
xCommand Camera Preset Store
Store the current position of the chosen camera. The camera is identified by the CameraId
parameter.
Note: The xCommand Camera Preset commands applies to an individual camera. This is in contrast
to the xCommand Preset commands where a single preset covers ALL connected cameras plus the
Video Input switcher settings. The xCommand Camera Preset commands are useful when you want
to handle multiple camera positions individually per camera, rather than working with complete sets
of camera positions.
PresetId: The ID of this camera preset. If not set explicitly, the codec will assign a preset ID
automatically.
CameraId: Which camera to store the position of.
ListPosition: The new camera preset's position in the list returned by the xCommand Camera Preset
List command.
Name: The name of the new camera preset. It will be used in the list returned by the xCommand
Camera Preset List command.
Requires user role: USER
Parameters:
PresetId: <1..35>
CameraId (r): <1..1>
ListPosition: <1..35>
Name: <S: 0, 255>
Example:
xCommand Camera Preset Store PresetId: 1 CameraId: 1 ListPosition: 1 Name
""
OK
*r CameraPresetStoreResult (status=OK)
** end
SX20 Codec API Reference Guide TC7.0, JANUARY 2014.
D14949.08
About the API xConfiguration
Conference commands
xCommand Conference DoNotDisturb Activate
xCommand Conference DoNotDisturb Deactivate
xCommand Conference ActiveSpeaker Reset
93
xCommand xCommand
This command switches on the Do Not Disturb mode, and the Timeout parameter allows you
to control when it is switched off again. It only takes effect when xConfiguration Conference
DoNotDisturb Mode is set to Timed.
When Do Not Disturb is switched on, all incoming calls are rejected and registered as missed calls.
The calling side receives a busy signal.
Timeout: The number of minutes before Do Not Disturb is switched off. If not set, Do Not Disturb
times out after 1440 minutes (24 hours).
Requires user role: USER
Parameters:
Timeout: <0..1440>
Example:
xCommand Conference DoNotDisturb Activate
*r ActivateResult:
** end
This command switches off the Do Not Disturb mode. This command only takes effect when
xConfiguration Conference DoNotDisturb Mode is set to Timed. When Do Not Disturb is switched
off incoming calls come through as normal.
Requires user role: USER
Example:
xCommand Conference DoNotDisturb Deactivate
*r DeactivateResult:
** end
Resets ActiveSpeaker. Normal voice switching is switched back on.
Requires user role: USER
Example:
xCommand Conference ActiveSpeaker Reset
*r ConferenceActiveSpeakerResetResult (status=OK):
** end
API Reference Guide
xStatus Appendices
Copyright © 2014 Cisco Systems, Inc. All rights reserved.