Call Commands - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec
Contents Introduction
Boot commands
xCommand Boot
Reboot system.
Action: As a default the system restarts after a reboot. By selecting Shutdown, the system will not
restart.
Requires user role: USER
Parameters:
Action: <Restart/Shutdown>
Example:
xCommand Boot
*r BootResult (status=OK):
** end
OK
CUIL reboot request, restarting
Connection closed by foreign host.
SX20 Codec API Reference Guide TC7.0, JANUARY 2014.
D14949.08
About the API xConfiguration

Call commands

xCommand Call Accept
xCommand Call Reject
83
xCommand xCommand
Accept an incoming call. If no CallId is specified, all incoming calls are accepted. The CallID is
returned when the xCommand Dial command is run. During the call you can run the xStatus Call
command to see the CallId. CallType parameter is not in use.
Requires user role: USER
Parameters:
CallId: <0..65534>
CallType(o): <Audio/Video> Not in use.
Example:
xCommand Call Accept CallId:19
OK
*r CallAcceptResult (status=OK):
** end
Reject incoming call. If no call id is specified, all incoming calls are rejected. The CallID is returned
when the xCommand Dial command is run. During the call you can run the xStatus Call command to
see the CallId.
Requires user role: USER
Parameters:
CallId: <0..65534>
Example:
xCommand Call Reject CallId:20
OK
*r CallRejectResult (status=OK):
** end
API Reference Guide
xStatus Appendices
Copyright © 2014 Cisco Systems, Inc. All rights reserved.