Caliper Coupling Module - Honeywell TMS 9250 User Manual

1. TMS 9250 Torque Measurement System
008-0738-00
Figure 3: General Precautions to be Considered for Rotor and CCM Installation

Caliper Coupling Module

The caliper coupling module must be firmly mounted to a non-rotating support structure. It
must be aligned with the annular printed circuit board antenna so that the air gap between the
16
© 2012 – Honeywell International Inc. All rights reserved
Figure 2: Complete Setup Connection Representation
Note:
Pilot diameters in accordance with ANSI B4.1 (ANSI
1.
standards for limits and fits)
Mating driveline components shall be more than 1.5
2.
inches around the rotating antenna and 2.0 inches
around CCM.
Minimum safety shield clearance of 1.5 inches shall be
3.
provided between the rotating antenna and test stand
safety shields.
Signal loss will occur if maximum component diameter
4.
or minimum safety shield clearance is not maintained
more than 2.0 inches around CCM.
TMS 9250 Product User Manual Rev B
April 2012