Table of Contents
Advertisement
1.5
Installation and Setup
Bolting Information
Tighten all bolts, in incremental steps, to the bolt manufacturer's rated torque specification.
Use the respective sequence illustration shown in Figure 1 depending on the number of bolts
the sensor requires. This bolting sequence applies to both bolt circles of the torque sensor.
Typical connection schematic of the product for any torque measurement is as shown in
Figure 2. General guidelines shall be considered for mounting the sensor as shown in Figure
3. Outline dimension details for standard models are indicated in Figure 4 to Figure 9; contact
factory for other configurations.
Torque Sensor
Honeywell's TMS 9250 series torque sensors may be operated horizontally, vertically, or at
any angle in between, provided the load is applied through the loading axis. All torque sensors
in this series have bolt patterns that mate directly to standard DIN companion flanges. When
mounted, one of the flanges should be mated to a good quality double flex coupling or a
driveshaft arrangement that incorporates universal joints at each end. This is designed to
compensate for angular and parallel misalignment. Avoid applications that place extraneous
loads on the torque sensor.
Plug Top
Power
sunpower
Supply
Rev B
April 2012
© 2012 – Honeywell International Inc. All rights reserved
Figure 1: Bolting Pattern for Flange Model
DC Cable
RS 232 Cable For
To SPM
Computer Interface
TMS 9250 Product User Manual
1. TMS 9250 Torque Measurement System
SPM
Belden Tri-axial RF cable
008-0738-00
Rotor
CCM
15
Advertisement
Table of Contents
