Using the Control Panel
9.2.7 System Meters Screens
The System Meters screens show the total system and individual UPS unit meter readings
from any unit, when a parallel system is installed. The default voltage displayed on these
screens is phase-to-neutral. However, an authorized Eaton Customer Service Engineer can
change the screens to display the voltage phase-to-phase (A-B, B-C, C-A).
Press the METERS pushbutton on the main menu bar to display the Unit Meter screens.
Press the SYSTEM pushbutton on the menu bar to display the System Meters screen.
Use the
then press the SELECT pushbutton to display the screen.
9-28
EATON Powerware
or
pushbuttons to highlight the Total System meter or Unit meters desired,
SYSTEM METERS
TOTAL SYSTEM
UNIT 1
UNIT 2
ENTER PASS-
UNIT 3
WORD
UNIT 4
Figure 9-31. System Meters Screen
9390 UPS (100–160 kVA) Installation and Operation Manual S 164201554 Rev E powerware.com
®
SELECT