Compuprint L03 User Manual page 73

Adjusting the Tear-Off Position:
MENU ENGLISH
TEAR ADJUST: −30
TEAR ADJUST: ...
TEAR ADJUST: +360
BUZZER YES
TEAR ADJUST: These values adjust the distance between the Tear-Off Perforation and
xxx the Tear-Off Bar. The values correspond to 1/180 inch units, that is, the
tuning ranges between −1/6 and 2 inch. 0 is the default value.
See also "How to Use the Tear-Off Function" on page 79, later in this Section.
Resetting to Factory Default Values
With the BACK TO MFG function it is possible to reset all items in the Power On
Configuration Setup and in the Program Setup to their factory default values. This
may be useful if you do not remember the values you set in the setups, or because
you simply changed your mind about the settings you have just done. The default
values for the setup items are indicated in bold.
FUNCTIONS
BACK TO MFG: NO
and PROGRAM
PRINT OUT ?
If you want to select BACK TO MFG:YES, you have to exit from this item using
the or the key, in order to confirm the selection of this value.
At this point, the Power On Configuration Setup procedure is finished. If you exit
pressing the and the PROGRAM key, the new settings will be saved.
Do not power off the printer before all data have been written into the NVM and
the printer has returned online.
or
or
or
or BACK TO MFG: YES
Chapter 3. Configuring the Printer
61