Host Computer Connection; Software Driver Selection - Compuprint L03 User Manual

Host Computer Connection

This printer can be connected to your host computer with the interfaces available
on the Controller Board you have found in the printer box and installed on the
rear of the printer.
There are two types of Controller Boards:
1. Controller Board with a bidirectional IEEE1284 parallel interface and Ethernet
2. Controller Board with a bidirectional IEEE1284 parallel interface, Serial
Insert the host computer cable(s) into the back of the printer as shown below.
Parallel
Interface
Controller Board with parallel interface and

Software Driver Selection

At this point it is necessary to configure your printer for your application package.
The installation procedures depend upon the host environment.
In a WINDOWS environment the printer supports the Plug & Play feature.
14
User's Guide
10/100 BaseT LAN interface.
RS-232/C 9-pin interface and USB 2.0 interface.
DANGER
<1-14> Switch off printer power and unplug the printer power cord
before connecting or disconnecting a communication port, a teleport, or
other attachment connector.
Ethernet 10/100 BaseT LAN interface.
Serial
Interface
Parallel
Interface
Ethernet
Interface
Controller Board with parallel interface,
Serial interface, and USB interface.
USB
Interface