Using Two Sets Of Tuning Constants; Table 4-7 Set Up Procedure; Table 4-8 Procedure For Switching Pid Sets From The Keyboard - Honeywell UDC 2300 User Manual

Operation
4.9

Using Two Sets of Tuning Constants

Introduction
You can use two sets of tuning constants for single output types and choose the
way they are to be switched. (Does not apply for Duplex control.) See table
below.
Step
1 Select Tuning Set
Up Group
2 Select the tuning
constants
3
Switch between two sets via keyboard (without automatic switch-over)

Table 4-8 Procedure for Switching PID SETS from the Keyboard

Step Operation
1 Select Control
Set-up Group
2
48

Table 4-7 Set Up Procedure

Operation Press
SET UP
FUNCTION
[ ] [ ]
Press
DISPLAY
[ ] [ ]
UDC2300 Universal Digital Controller User Manual
Action
until you see TUNING in the Lower
Display
to successively display the available
constants in the Lower Display. The
value is displayed in the Upper
Display
To change the value of any of the
above listed prompts in the lower
display.
Result
Until you see:
Upper Display = (the PV value)
Lower Display = PIDS X(X= 1 or 2)
To change PID SET 1 to PID SET2 or
Vice Versa.
You can use Accutune on each set.
4/00