Honeywell UDC 2300 User Manual page 29

Procedure
ATTENTION
The prompting scrolls at a rate of 2/3 seconds when the SET UP or FUNCTION key is held in.
Also, [ ] [ ] keys will move group prompts forward or backward at a rate twice as fast.
Step Operation
1 Enter Set Up
Mode
2 Select any Set
Up Group
3 Select a
Function
Parameter
4 Change the
Value or
Selection
5 Enter the Value
or Selection
6 Exit
Configuration
4/00
Table 3-1 Configuration Procedure
Press
SET UP Upper Display = SET
Lower Display = TIMER (This is the first Set Up
Group title)
SET UP Sequentially displays the other Set Up group titles.
You can also use the [ ] [ ] keys to scan the Set
Up groups in both directions. Stop at the Set Up
group title that describes the group of parameters
you want to configure. Then proceed to the next
step.
FUNCTION Upper Display = the current value or selection for the
first function prompt of the selected Set Up group.
Lower Display = the first Function prompt within that
Set Up group.
Sequentially displays the other function prompts of
the Set Up group you have selected. Stop at the
function prompt that you want to change, then
proceed to the next step.
[ ] [ ] Increments or decrements the value or selection that
appears for the selected function prompt. If you
change the value or selection of a parameter while in
Set Up mode then decide not to enter it, press [MAN-
AUTO/RESET] once—the original value or selection
is recalled.
Enters value or selection made into memory after
FUNCTION
another key is pressed.
Exits configuration mode and returns controller to the
DISPLAY
same state it was in immediately preceding entry into
the Set Up mode. It stores any changes you have
made.
If you do not press any keys for 30 seconds, the
controller times out and reverts to the mode and
display used prior to entry into Set Up mode.
UDC2300 Universal Digital Controller User Manual
Configuration
Result
21