4.5 Setpoints
Introduction
You can configure the following setpoints for the UDC2300 controller.
A Single Local Setpoint (SP)
2 Local Setpoints (SP, 2L)
a Local Setpoint and a Remote Setpoint (SP, RS)
Switching between setpoints
You can switch Local and Remote setpoints or between two Local setpoints
when configured.
ATTENTION The REMOTE SETPOINT value cannot be changed at the
keyboard.
Table 4-6 Procedure for Switching Between Setpoints
Step
Operation
1
Select the
Setpoint
4/00
Press
FUNCTION To alternately select Local Setpoint 1 (LSP) and the
Remote Setpoint (RSP) or switch between the 2 Local
Setpoints (LSP and 2L)
ATTENTION
lower display, if:
the remote setpoint or 2
configured as a setpoint source
you attempt to change the setpoint while a
setpoint ramp is enabled, or
if you attempt to change the setpoint with the
setpoint select function key disabled.
UDC2300 Universal Digital Controller User Manual
Result
"KEY ERROR" will appear in the
nd
local setpoint is not
Operation
45