Initial Start-Up; Figure 2-16 Transmitter Power For 4-20 Ma - 2 Wire Transmitter Using Open Collector Alarm 2 Output (Model Dc230B-Xt-Xx-Xx-Xxxxxxx-Xx-X); Figure 2-17 Transmitter Power For 4-20 Ma - 2 Wire Transmitter Using Auxiliary Output (Model Dc230B-Xx-2X-Xx-Xxxxxxx-Xx-X) - Honeywell UDC 2300 User Manual

INPUT 1
Figure 2-16 Transmitter Power for 4-20 mA — 2 wire Transmitter Using Open
Collector Alarm 2 Output (Model DC230B-XT-XX-XX-XXXXXXX-XX-X)
INPUT 1
Figure 2-17 Transmitter Power for 4-20 mA — 2 Wire Transmitter
Using Auxiliary Output (Model DC230B-XX-2X-XX-XXXXXXX-XX-X)

2.7 Initial Start-up

Overview
This section gives you the information necessary to start up your controller prior
to configuration. Review the Operator Interface portion (Subsection 2.8) to make
sure you are familiar with the indicator definitions and key functions.
Apply Power
When power is applied, the controller will run three diagnostic tests. After these
tests are completed, "TEST DONE" is displayed.
4/00
8 +
OUTPUT 2
7 -
8 +
7 -
AUXOUT
UDC2300 Universal Digital Controller User Manual
2 Wire Transmitter
_
9 –
+
10+
Configure:
A2S1TYPE = NONE
A2S2TYPE = NONE
2 Wire Transmitter
_
+
13 +
Configure:
14 -
AUXOUT = OUT
Auxiliary Output Calibration
ZEROVAL = 4095
SPANVAL = 4095
Installation
17