Installing Unit On Universal Rack Mount Kit - NEC S2500 User Manual

1.2 Installing Unit on Universal Rack Mount Kit

Installation of Rails
NOTE: There are two types of rails, one for angle holes on a
rack and the other for round holes. See the proper procedure
depending on the type of the rail you use.
Each of the following procedures supposes that a rail is
installed on the left part of a rack when the rack is viewed from
its front.
Install a rail on the right part of the rack in a similar manner.
The left and right rails are different from each other. Use the
correct rail when installing it on the rack. (See the figure
below.)
For each rail, align the face with the label to the rear (see the
figure below).
Front
Upper: Rail (R) Lower: Rail (L)
Rail (L)
D-5
Rear