Installation And Connection Of The Disk Array Unit - NEC S2900 User Manual

1.3 Installation and Connection of the Disk Array Unit

Do not use the disk array unit in an area of high humidity. If so, a fault,
electrical shock, or fire may occur.
Do not use the disk array unit in an area where inflammable gas and/or
combustible substances are used. If so, fire or anexplosion may occur.
Do not install the disk array unit in a dirty or dusty environment. Remove
any dust adhering to AC outlets and the plugs of power cords. Any dust
adhering to an AC outlet and/or plug, may be a potential cause of fire.
Avoid overloading AC outlets with too many devices. If so, fire may occur.
Do not put any heavy materials on a power cord. If so, the coating of the
power cord may be damaged, fire may occur, and/or you may be electrically
shocked.
Always dry your hands prior to connecting the plug of a power cord to an
AC outlet. If not, you may be electrically shocked.
Make sure to disconnect all power cords and FC cables before relocating
the disk array unit. If not, a malfunction of the system, an electric shock
and/or fire may occur.
The disk array unit can accept power between 100 - 240 VAC (50/60 Hz).
Using power of different voltage may cause electric shock, smoke, and/or
fire to occur.
Do not install the disk array unit and the power cords in an area of direct
sunshine or near any apparatus generating heat such as a heater. If so, a
fault may occur. Further, the insulating coating of the power cord may be
damaged causing fire or electric shock to occur.
The array controller and the disk enclosure weigh 34 kg or more. Hold the
array controller and disk enclosure firmly using at least three people to carry
it. Carrying the devices only by two or less people may cause personal
injury or damage to the unit.
Select the place where the disk array unit can be connected to the AC
outlet by using the attached power cord.
Insert the plug of a power cord into an AC outlet securely. If some
clearance remains between the plug of the power cord and the AC outlet,
dust may enter into the clearance. This then may cause fire to occur.
Provide sufficient margins for the cables connected to the disk array unit so
that the cables do not present an entanglement problem. Prevent power
plugs and FC connectors from suffering excessive force.
WARNING
CAUTION
3