Round Hole Fitting Rail - NEC S2500 User Manual

Disk array unit
Hide thumbs Also See for S2500:
Table of Contents

Advertisement

1.2.2

Round Hole Fitting Rail

NOTE: Each rail has a rail support attached. When a rail is
installed on a rack with round holes, remove the rail support
from the rail.
1. Remove the rail support installed previously from each rail by removing four screws (two on
the front and the other two on the rear).
Remove
2. Loosen the four flush screws at the rear side of the rail.
After loosening the screws, make sure that the moving part of the rail can slide smoothly.
NOTE: Do not remove the flush screws.
D-12
Remove

Advertisement

Table of Contents
loading

This manual is also suitable for:

S1500Nf2500-sr40eNf1500-sr40e

Table of Contents