Notes On Use - NEC S2500 User Manual

The following includes information necessary for proper and safe operation of the disk array unit.
•
Do not use the disk array unit in an area of high humidity or water usage. If so, a
fault, electrical shock, or fire may occur.
•
Do not use the disk array unit in an area where inflammable gas and/or
combustible substances are placed. If so, fire or explosion may occur.
•
Do not overload AC outlets with power cords. If so, fire may occur.
•
Do not put any heavy materials on a power cord. If so, the coating of the power
cord may be broken, fire may occur, and/or you may be electrically shocked.
•
Do not install the disk array unit in a dirty or dusty environment. Remove any dust
adhering to AC outlets and the plugs of power cords. Should any dust remain
adhering to an AC outlet and/or plug, fire may occur.
•
Do not connect the plug of a power cord to an AC outlet with a wet hand. If so, you
may be electrically shocked.
•
While the disk array unit NFx500-SR40E can accept the power in the range of 100
- 240 VAC (50/60 Hz), the power cord shipped with the disk array unit can only
accept 100 – 120 VAC. Use 100 – 120 VAC (50/60 Hz) when the included power
cord is used. Using power of a different voltage may cause electric shock, smoke,
and/or fire to occur.
•
The controller of the disk array unit contains a lithium battery. Do not remove the
lithium battery. The lithium battery may explode when it is brought close to fire or
immersed in water. Dispose of the controller according to local ordinances.
Contact your local government for details.
•
If the disk array unit does not operate normally due to the life of the lithium
batteries, contact your service representative. Do not disassemble the controller,
or replace or charge battery by yourself.

Notes on Use

WARNING
iv