To remove this delay, scan the Delay Length barcode, and set the number of
steps to 00. Scan the SAVE barcode from the inside back cover.
Interfunction Delay
This is a delay of up to 495 milliseconds (in multiples of 5) placed between the
transmission of each segment of the message string. You can program up to 99
steps (of 5 ms each). Scan the Interfunction Delay barcode below, then scan
the number of steps, and the SAVE barcode from the inside back cover.
Note: If you make an error while scanning the digits (before scanning Save),
scan Discard on the inside back cover, scan the Interfunction Delay
barcode, scan the correct digits, and Save again .
To remove this delay, scan the Interfunction Delay barcode, then set the number
of steps to 00. Scan the SAVE barcode from the inside back cover.
Intermessage Delay
This is a delay of up to 495 milliseconds (in multiples of 5) placed between each
scan transmission. You can program up to 99 steps (of 5 ms each). Scan the
Intermessage Delay barcode below, then scan the number of steps, and the
SAVE barcode from the inside back cover.
Note: If you make an error while scanning the digits (before scanning Save),
scan Discard on the inside back cover, scan the Intermessage Delay
barcode, scan the correct digits, and Save again .
1st Scan Transmission
Intermessage Delay
To remove this delay, scan the Intermessage Delay barcode, then set the num-
ber of steps to 00. Scan the SAVE barcode from the inside back cover.
4 - 8
Prefix
Scanned Data
STX
1
HT
Interfunction Delays
Intermessage Delay
Suffix
2 3 4 5
CR
Interfunction Delay
2nd Scan Transmission
LF