Table of Contents
Advertisement
Intercharacter Delay
This is a delay of up to 495 milliseconds (in multiples of 5) placed between the
transmission of each character of scanned data. You can program up to 99
steps (of 5 ms each). Scan the Intercharacter Delay barcode below, then scan
the number of steps, and the SAVE barcode from the inside back cover.
Note: If you make an error while scanning the digits (before scanning Save),
scan Discard on the back cover, scan the Intercharacter Delay barcode,
scan the correct digits, and Save again.
To remove this delay, scan the Intercharacter Delay barcode, then set the num-
ber of steps to 00. Scan the SAVE barcode from the inside back cover.
User Specified Intercharacter Delay
This is a delay of up to 495 milliseconds (in multiples of 5) placed after the
transmission of a particular character of scanned data. You can program up to
99 steps (of 5 ms each) to follow the character you specify. Scan the Delay
Length barcode below, then the number of steps for the delay, and the SAVE
barcode from the inside back cover.
Next, scan the Character to Trigger Delay barcode, then the 2 digit hex value for
the ASCII character that will trigger the delay (refer to the Decimal to Hex to
ASCII conversion chart on
Note: If you make an error while scanning the digits (before scanning Save),
scan Discard on the inside back cover, scan the Character to Trigger
Delay barcode, scan the correct digits, and Save again .
Character to Trigger Delay
Prefix
Scanned Data
1
2
3
Intercharacter Delay
page
4-4).
Suffix
4
5
Intercharacter Delay
Delay Length
4 - 7
Advertisement
Table of Contents
