Non Decoded Laser Emulation Idle
The idle describes the state of the scanner when no data is being transmitted.
When in Non Decoded mode, you must set the scanner's idle state to match the
idle state for the device to which the scanner is connected. Default = High.
Low
* High
Disabling the Secondary Interface
You can temporarily disable the secondary interface, but still retain the second-
ary interface settings in the scanner's memory by scanning the Disable barcode
below. To re-enable the secondary interface, scan the Enable barcode. Default
=Disable .
* Disable
Enable
Secondary Trigger Mode
Manual Trigger: You must press the scanner trigger to scan. When not scan-
ning, idle power is maintained. Default = Manual Trigger .
* Manual Trigger
6 - 3