Interfunction Delay; Intermessage Delay - Honeywell Xenon 1900 User Manual

Next, scan the Character to Trigger Delay bar code, then the 2-digit hex value for a printable character to trigger the delay
(see Lower ASCII Reference
Delay Length
To remove this delay, scan the Delay Length bar code, and set the number of delays to 0. Scan the Save bar code using
the Programming Chart

Interfunction Delay

An interfunction delay of up to 5000 milliseconds (in 5ms increments) may be placed between the transmission of each
control character in the message string. Scan the Interfunction Delay bar code below, then scan the number of 5ms
delays, and the Save bar code using the
To remove this delay, scan the Interfunction Delay bar code, then set the number of delays to 0. Scan the Save bar code
using the Programming Chart

Intermessage Delay

An intermessage delay of up to 5000 milliseconds (in 5ms increments) may be placed between each scan transmission.
Scan the Intermessage Delay bar code below, then scan the number of 5ms delays, and the Save bar code using the
Programming Chart inside the back cover of this manual.
To remove this delay, scan the Intermessage Delay bar code, then set the number of delays to 0. Scan the Save bar code
using the Programming Chart
6 - 4
)
Table, page A-4.
inside the back cover of this manual.
Programming Chart
Prefix
STX 1 HT
Interfunction Delay
inside the back cover of this manual.
1st Scan Transmission
Intermessage Delay
inside the back cover of this manual.
inside the back cover of this manual.
Scanned Data Suffix
2 3 4 5 CR LF
Interfunction Delays
2nd Scan Transmission
Intermessage Delay
Character to Trigger Delay