Trigger Commands; Resetting The Factory Settings - Honeywell 3800 User Manual

Trigger Commands

You can activate and deactivate the scanner with serial trigger commands.
First, the scanner must be put in Manual/Serial Trigger Mode either by scanning
the Manual/Serial Trigger Mode barcode (page 3-4), or by sending the Manual/
Serial Menu Command (page 12-8). Once the scanner is in serial trigger mode,
the trigger is activated and deactivated by sending the following commands:
Activate:SYN T CR
Deactivate:SYN U CR
The scanner scans until a barcode has been read, until the deactivate com-
mand is sent, or until the serial time out has been reached (see "Serial Trigger
Time Out" on page 3-5 for a description, and the serial command on page 12-
8).

Resetting the Factory Settings

If you aren't sure what programming options are in your scanner, or you've
changed some options and want the factory settings restored, scan the Factory
Default Settings barcode below.
Factory Default Settings
The following chart lists the factory default settings (indicated by an asterisk (*)
on the programming pages).
12 - 4