Good Read Delay; Trigger Mode - Honeywell 3800 User Manual

Good Read Delay

This sets the minimum amount of time before the scanner can read another
barcode. Default = No Delay.
* No Delay
Short Delay
Medium Delay
Long Delay

Trigger Mode

Manual/Serial Trigger: You can activate the scanner either by pressing the
trigger, or using a serial trigger command (see "Trigger Commands" on page 12-
4). When in manual trigger mode, the scanner scans until a barcode is read, or
until the trigger is released.
When in serial mode, the scanner scans until a barcode has been read or until
the deactivate command is sent. In serial mode, the scanner can also be set to
turn itself off after a specified time has elapsed (see Serial Trigger Time Out,
which follows). Default for 3800.
Manual/Serial Trigger
Serial Trigger Time Out: Use this selection to set a time out (in quarter sec-
onds) of the scanner's trigger when using serial commands to trigger the scan-
ner. Once the scanner has timed out, it must be triggered again either serially
3 - 4