imagistics fx2080 User Manual page 376

Message on the display
The NetBIOS name
entered is already in
use.
The number of file
attachments and/or
file size limit has been
exceeded. Please delete
attachments until you
reach the acceptable
limit.
The number of the
browse results exceeds
the limit.
The numeric keypad
cannot be used.
The storing process has
not finished.
The toner is empty.
The toner is low.
The value entered
exceeds the limit. Please
enter a value within the
listed range.
There are no vacant
numbers.
There is no applicable
data.
This function cannot be
used.
This Resolution cannot
fit specified Zoom value.
This setting is protected
To initialize IP address
you must shutdown.
Toner should be
replaced.
Too many characters
Too many locations.
TTI data has not been
registered
Unable to delete.
Use the scanner glass
14-22 m
aintenance
The NetBIOS name conflicts with other device. Contact your Network Administrator.
You can add up to 10 network files (or up to 10 MB worth of files) to the scanned job.
Delete files so that it meets the limit.
You browsed a folder where too many files or folders are located. To scan to the folder,
register the folder as a shortcut using the [Keypad] or select another folder. To attach
files from the folder, copy the files to a new folder and attach them.
You cannot use numeric keys while selecting group members.
The machine cannot execute the job until the current job finishes. Please wait.
Toner is empty. Replace with a new toner bottle.
Your machine is almost out of toner.
In the USA, please call for supplies 1-800-462-6797.
You entered a value or number that exceeds the range. Confirm the range on the display
and enter it again.
You have already registered 300 locations to the Address Book. To register a new loca-
tion, first delete the unnecessary locations first.
You selected a key on the index, to which no destination is categorized.
You selected a function that is currently not available. Change the function you set prior
to this function or cancel this function.
You try to set a resolution that is not available in the set zoom ratio. Change either the
resolution or the zoom ratio to do the job.
The department management setting is protected. To change the setting, release the
protection.
IP address is entered or edited. Power off and then on to save the setting.
Toner is empty. Replace with a new toner bottle.
You entered more characters than the limit. Re-enter them so that it contains the limit.
You entered more location than the limit. Re-enter them so that it contains the limit.
The Transmit Terminal Identifier (TTI) is not registered. To select the TTI, register the
TTI in advance.
The job you selected was carried out before deleting.
You tried to make a zoom up copy using the ADF. To make a zoom up copy, use
the document glass.
& t
roUBleShootinG
Description / Solution