imagistics fx2080 User Manual page 315

• If you press [Enter] without entering the PIN, the machine will beep and
display "The following data is required: PIN", and then return to step 2.
Press [Reset] to return to the standby mode.
Registering program one-touch keys (Mode 1)
In Mode 1, you must register a PIN to the program one-touch key. Transmission
will not be possible if a PIN number has not been registered. If Mode 2 has been
set, the following procedure is not necessary.
1
Registering or editing an entry using the program one-touch keys.
(See page 10-14, if necessary.)
2
Enter the phone number, then press the * ("star") to enter the PIN.
The PIN always follows the fax number.
For example, to dial 98776544 with a PIN of "12345678", enter
98776544*12345678.
– or –
U se the address book and specify the number that contains the PIN number.
(See "Registering the address book" on page 11-8.)
NOTE: You cannot specify the destination if a PIN has not been registered. For details
on registering a PIN number in the address book, see "Registering the address
book (Mode 1)" on page 11-8.
3
Press [Enter] to save the number.
• If you press [Enter] without entering the PIN, the machine will beep and
display "The following data is required: PIN", and then return to step 2.
Press [Reset] to return to the standby mode.
4
(1) Press [Others] and register the advanced communications.
(2) Press [Enter] twice to save the settings.
r
eStrictinG USe oF the machine
1
2
3
4
5
6
7
8
9
10
11
12
13
AI
11-9