imagistics fx2080 User Manual page 336

The underlined settings are the factory defaults.
Function
Redial Attempts This sets the number of times for redial attempts when the destination line is busy. The
interval between redial attempts is set at "Redial Interval".
Redial Interval This sets the interval between redial attempts.
Block Junk Fax This function enables you to block receipt of unnecessary faxes.
(See page 3-46.)
Number of This sets the number of times the machine will ring before fax reception when the recep-
Rings tion mode is set to Fax or Tel/Fax.
Dialing Pause This sets the default for the dialing interval (2-10 seconds) when the pause symbol is
input.
Super-Fine This sets the dpi for resolution when a document is scanned for S-Fine transmission. If
Resolution 600 dpi is set, the scan is sharper than with 400 dpi; however, it may result in memory
overflow when the document is sent.
Rx Reduction Select from [Auto], which automatically selects the magnification according to the length
Rate of the received document, or [100%] to have all faxes printed out at the same rate of
(See page 3-20.) reduction.
Reduction This sets at what point the document printout will extend to the following page if the
Margin received document cannot fit within the effective recordable area.
(See page 3-20.)
Paper Saving This sets the print method for the received documents.
(See page 3-21.) If it is set to "H-Page Rx" and 2 pages of Half-Letter is received in succession, the two
pages will be reduced at the appropriate rate and printed out on one sheet of paper.
If it is set to "Duplex Rx*", both sides of each sheet of paper will be used for printouts.
Quick Memory If this is set to [ON], fax transmission for multiple documents will begin in the page order
Tx when it has been scanned and stored.
ECM Mode Any part of a fax that was not send correctly due to the line error will automatically be
resent. (The destination must have the same function for it to work.)
Service Mode Do not set.
Dial PreFix The connection number as Dial PreFix No. can be registered to allow easy access to other
(See page 3-44.) phone networks.
Receive Time If this is set to [ON], the received date (year, month, day) and time can be printed with
Stamp the word "Received" at the header of the received document.
NOTE: If the receiving reduction rate is fixed to 100% and the reduction margin setting
is small, the received document could be divided into 2 sheets by attaching the
Receive Time Stamp.
12-6 m S
achine ettinGS
Description
MAY 5 2005 02:16pm
MAY 5 2005 02:15pm
Setting
2–15 times: 2
times
1–5 minutes: 1
minute
1–10 times: 2
times
2–10 seconds: 2
seconds
600dpi
400dpi
Auto
100%
0.0–3.3 inches:
1.5 inches
OFF
H-Page Rx
Duplex Rx
ON
OFF
ON
OFF
OFF
OFF
ON
P.01/01