Conventions Used In This Manual; Led And Sounder Indicators - Alarm Lock NETWORXPANEL Programming Instructions Manual

Conventions Used in this Manual

Enabling/Disabling Users (By User Number)
Function
Description
User Number must be between 2 and 5000.
NOTE: Will Enable/Disable users even if the user is associated with an enabled group.
Programming
Information
Function
Number
General Program Mode Information
If a wrong key is pressed during code entry, press the ; key until the error sound is heard (7 short beeps), this will clear the entry. Re-
enter the key sequence again. All program sequences are followed by the : key; 2 short beeps indicate a successful program sequence.
The NETPDK / NETDK keypads provide visual and audible feedback. With a fully charged battery, the feedback is as follows:
ACTIVITY
Keypress
Access Granted or Remote Release
Invalid Code
Successful Program Entry
Unsuccessful Program Entry
Exit Program Mode
Valid but Disabled Code
Emergency Commands are in effect
NETWORXPANEL Low Battery
NETDK or NETPDK set to primary
NETDK or NETPDK set to
secondary
3. Disable User
4. Enable User
Function
Name

LED and Sounder Indicators

LED
FLASHES
1 RED
2 GREEN
7 RED
2 GREEN
7 RED
1 RED, 2
GREEN
1 GREEN, 4
RED
1 RED every
two seconds
--
1 RED
2 RED
; 3 ; [ _ _ _ ] :
; 4 ; [ _ _ _ ] :
Programming Key Sequence
SOUNDER
BEEP(S)
1
2
7
2
7
10
1 long, 5 short
--
--
Keypad Identification Feature when two keypads
--
Keypad Identification Feature when two keypads
--
2
Minimum Required Program Level
Program Levels are abbreviated as follows:
M = Master
4 = Installer
3 = Manager
2 = Supervisor
This Program Level abbreviation is the
minimum program level required to ac-
cess the particular Function.
higher the level, the more programming
tasks the User is allowed, with Master
. allowing all tasks).
COMMENTS
Normal Operation
Remote release enabled through
activation of relay
Re-enter User Code
When in Program Mode
When in Program Mode
Code exists in memory, but disabled
--
Warning displayed in the DL-Windows
"Status" screen
are wired to the NETWORXPANEL
are wired to the NETWORXPANEL
(The
9