Alarm Lock NETWORXPANEL Tech Tip

A
345 Bayview Avenue, Amityville, New York, U.S.A. 11701
For Sales and Repairs 1-800-ALA-LOCK • For Technical Service 1-800-645-9440
Fax: 631-789-3383 • info@alarmlock.com
Note: Technical Service is for security professionals only
A L
LARM OCK
TECH TIP
Date: Thursday, July 16, 2015
Subject:

Programming the NETWORXPANEL Wireless Remote Release Buttons

Models: NETWORXPANEL
Whether the NETWORXPANEL is wired with one or two keypads or is configured for a single door or for
"Two Door Mode", the pairing of a wireless remote release button to the NETWORXPANEL is the same.
If the NETWORXPANEL is wired with two keypads, the pairing of the remote release button can be
performed at either keypad.
NETWORXPANEL.
1. At the locking device keypad, enter Program Mode (press the Master Code followed by ;).
2. To pair the first remote release button, press:
; 6 5 ; 1 :
Verify keypad sounds "beep-beep-beep" continuously.
NETWORXPANEL is ready to pair a remote release button; the NETWORXPANEL will wait about 30
seconds for the next step).
3. With the wireless remote in hand, observe its LED as you perform the next steps:
a. Press and hold one of the four buttons.
b. The red LED lights...keep holding the button...
c. When the LED flashes green, release the button...
d. Wait a few seconds...observe the LED as follows:
LED solid green = Pairing successful. Go to step 4 to pair another remote release button.
LED solid red = Pairing unsuccessful. Start again at step 2.
4. To pair another wireless remote release button, you must start again at step 2, but with a slight
change, as follows:
As previously stated, up to 10 wireless remote release buttons may be paired to the
L
LARM OCK
Tech Support
Up to 10 wireless remote release buttons can be paired to the
(The "beep-beep-beep" indicates the