Programming Functions - Alarm Lock NETWORXPANEL Programming Instructions Manual

1. New Master Code
•
Master Code must be 6 digits-only.
•
Master Code is Keypad Code Access only.
•
Factory Default = 123456
•
See "General Overview" on page 5 for more information about Master Codes.
2. Adding and Deleting User Codes and/or Proximity
Cards (for User Numbers 2-5000)
(Entering a "User Code" / "PIN No. Code" into the lock programming)
User Codes added with Function 2 are enabled for
use with ALL keypads in the system, including
Wiegand devices with keypads.
"Two Door Mode":
NETPDK keypads ("primary" and "secondary"), to
add User Codes for use with only the primary key-
pad or only the secondary keypad, see Functions
62 and/or 63. Using Function 2 with Two Door
Mode will add the User Code to both keypads.
• User Number must be between 2 and 5000.
• User Code must be 3-6 digits.
• Each User Code can be thought of as a person. As long as each person possesses their own
unique User Code, you can control access by adding or deleting User Codes. See "Terminology
Used in this Manual" on page 6 for more information.
Programming Level Defaults for the NETWORXPANEL
Users added will default to a Group Association and a Programming Level ability as follows:
USER TYPE
Master Code
Installer Codes
Manager Codes
Supervisor Codes
(Reserved)
Basic User Codes
Basic User Codes Group 1
Basic User Codes Group 2
Basic User Codes Group 3
Basic User Codes Group 4
Basic User Codes
Quick Enable User 300 Code
(Reserved--see page 7)
Guard Tour Code*
Service Code
Basic User Codes
*This code is a Non-Pass code and therefore does not allow passage through the door.
14

Programming Functions

USERS
(User Number 1)
For systems with two
USER NUMBER
10 - 11
12 - 50
51 - 100
101 - 150
151 - 200
201 - 250
251 - 296
301-5000
; 1 ;
(Entering a Proximity
Card)
(Deleting Entire User) ; 2 ;
GROUP DEFAULT
ASSOCIATION
1
2 & 3
4 - 6
7 - 9
297
298
299
300
[ _ _ _ _ _ _ ] ;
(New Master Code)
M
; 2 ; [ _ _ _ _ ]
(User Number)
[ _ _ _ _ ]
; 2 ;
(User Number)
[ _ _ _ _ ]
(User Number)
3
MINIMUM PROGRAM
LEVEL (See page 6)
-
none
none
none
none
none
1
2
3
4
none
none
none
none
none
none
[ _ _ _ _ _ _ ] :
(Confirm New Master Code)
; [ _ _ _ _ _ _ ] :
(User Code)
[ ]
:
Beep Beep Beep
(Present card to reader
within 10 seconds)
: [ ]
Beep Beep Beep
(If NETPDK, wait 10
seconds for beeping
to end)
M
4
3
2
--
none
none
none
none
none
none
none
none
none
none
none