3
Install the printer driver in the computer to use.
See Chapter 10, "Before Printing from Computers."
Using the Machine as a Scanner
The following operations and settings are required to use the machine as a scanner.
If you are using a NetWare network, NetBIOS network, or AppleTalk network, you cannot use this function.
1
Connect the machine to the network.
See "Connecting to a Network, " on p. 4-3.
See "Interface Settings, " on p. 4-9.
2
Set the machine to use the TCP/IP network.
See "TCP/IP Network Setup Procedures, " on p. 5-2.
See "Protocol Settings, " on p. 5-3.
Install the software for specifying scanner settings (Network ScanGear) into the computer
3
connected to the machine.
See Chapter 12, "Before Using the Remote Scan Function."
Operations Required to Use the Machine
1
1-11