Protocol Settings - Canon image RUNNER 3245 Getting Started Manual

Protocol Settings

This section describes how to specify the protocol settings for the machine using the control panel. If
you are configuring the settings for the first time, use the control panel of the machine.
After configuring the settings, you can change them using software other than the control panel of
the machine. For details, see e-Manual > Network.
Depending on the machine you are using, you may have to use optional equipment to print via an AppleTalk
network. For the equipment needed, see "Optional Equipment and System Requirements for Connecting to a
Network, " on p. 3-2.
1
On the Network Settings screen, press [ AppleTalk Settings] → specify the
following.
[On] for < AppleTalk>: You can use the AppleTalk network.
In [ Service Name], enter a name for the printer not longer than 32 characters.
The name you enter here appears on the Macintosh screen.
If you are using a network that is set up in zones, enter the name of the zone in [ Zone].
•
If there is more than one printer in the same zone, each printer must have a unique name.
•
You can also enter a zone name by pressing [Browse] and selecting the appropriate name from the
displayed list.
Protocol Settings 8-3
8