Open Nic For Ring Operation Test; Ring Operations Test; Close Nic Test; Running The Dos Diagnostic Tests - 3Com TokenLink Velocity TokenLink VelocityTM XL PCI Network Interface Card User Manual

Using the Diagnostic Program 6-3

Open NIC for Ring Operation Test

This test prepares the 3C359 NIC for a NIC ring operation
test and verifies the 3C359 NIC's ability to transmit and
receive data over the network. This test requires you to
connect to an STP or a UTP cable with a DAU, MAU, CAU,
or token ring switch at the other end.

Ring Operations Test

This test assesses communication on the ring. The
3C359 NIC must be attached to the ring to run this
test successfully. The 3C359 NIC also must be set to
the correct ring speed.

Close NIC Test

This test verifies the 3C359 NIC's ability to close the 3C359
NIC and terminate the Ring Operations Test. The 3C359
NIC must have been previously opened.

Running the DOS Diagnostic Tests

If you are using Windows 95 or Windows for Workgroups,
exit Windows and restart the PC in MS-DOS mode, or boot
from a DOS diskette. If you are running Windows NT, boot
from the DOS partition or boot from a DOS diskette to run
the diagnostic program.
1 If you are using the 3.5-inch diskettes, insert
TokenDisk diskette #1 in the drive (for example,
the A drive) and enter:
a:\3pcid
If you are using the TokenDisk CD, insert it in the
CD-ROM drive (for example, the D drive) and enter:
d:\3pcid
The DOS Configuration and Diagnostic Program window
is displayed with the Test menu selected, as shown in
Figure 6-2.