3Com TokenLink Velocity TokenLink VelocityTM XL PCI Network Interface Card User Manual page 48

3-18 C 3: N
HAPTER
The samples below show the server console display when
two 3C359 NICs are installed.
This is the Load/Bind sequence for the first of two NICs:
FS1:load c:tlnkpodi
Loading module tlnkpodi.lan
3Com TokenLink PCI Server MLID
Version 1.00c [date]
(C) Copyright 1993-97, 3Com Corp. All
rights reserved
Supported slot values are 1,2
Slot: 1
Data Rate = 16 Mbps.
Max Packet Size = 17954
IO Address Base = F480
Memory Basic Address = FF9EFE800
IRQ = 10
Number of transmit buffers (DPDs) configured = 5.
Number of receive buffers (UPDs) configured = 3.
MicroCode Version String = 01.20 10/20/97
The supported slot values shown are for the two 3C359
NICs in the server. The next line is where you enter the
address that you will use.
This is the Load/Bind sequence for the second of two NICs:
FS1:load c:tlnkpodi
Do you want to add another frame type for a
previously loaded board? n
Supported slot values are 4
Slot: 4
Data Rate = 16 Mbps.
Max Packet Size = 17954
IO Address Base = EC80
Memory Basic Address = FFDFFC00
IRQ = 11
Select board to bind:2
IPX LAN protocol bound to 3Com 3Com TokenLink
PCI Server MLID FS1:
Once you have determined the values for the NICs installed
in the server, you can use the SLOT= parameter to load the
driver either from the command line or by placing the load
command in the AUTOEXEC.NCF file to load automatically
each time the server is started.
N W E
OVELL ET ARE NVIRONMENTS