Installing An Os/2 Client Driver For Netware - 3Com TokenLink Velocity TokenLink VelocityTM XL PCI Network Interface Card User Manual

11 When the path for the configuration files is
displayed, verify that the path is correct and
press Enter.
12 Press Enter again to return to DOS and edit the
STARTNET.BAT file.
13 Add the NIC's slot number in the STARTNET.BAT file
as follows:
load c:\novell\client32\tlnkpodi.lan frame=token-ring msb slot=<nnnn>
where <nnnn> is the slot number.
If you do not know your NIC's slot number, you can turn off
your PC, remove the cover, and check the slot.
14 On the same LOAD line, you can set the NIC's ring
speed as follows.
load c:\novell\client32\tlnkpodi.lan...ringspeed=<auto | 4 | 16>
where <auto | 4 | 16> is the ring speed setting:
15 Restart your workstation to start Client32.
The system prompts you for the 3C359 NIC's slot when the
TLNKPODI.LAN driver is loaded.

Installing an OS/2 Client Driver for NetWare

This section describes installing the driver for an OS/2
client. Before installing the OS/2 ODI driver from the
TokenDisk diskette or TokenDisk CD, ensure that the OS/2
operating system is installed and that the computer boots
without errors. Install the 3C359 NIC as described in
Chapter 2.
The Novell NetWare OS/2 ODI driver (TLNKPODI.SYS) is
available on the TokenDisk CD or TokenDisk diskette #1.
Installing an OS/2 Client Driver for NetWare
Auto — Allows the NIC to automatically detect the ring
speed. (This is the default setting.)
4 — Disables auto ring speed detection and sets the
NIC ring speed at 4 Mbps.
16 — Disables auto ring speed detection and sets the
NIC ring speed at 16 Mbps.
3-7