Using The Configuration Program - 3Com TokenLink Velocity TokenLink VelocityTM XL PCI Network Interface Card User Manual

B
You can change the 3C359 NIC's configuration settings
through a DOS Configuration and Diagnostic Program
provided on TokenDisk diskette #1 and on the
TokenDisk CD.
This appendix provides configuration instructions.
Instructions for testing the NIC with the diagnostic
part of the DOS Configuration and Diagnostic Program
are located in Chapter 6, "Troubleshooting."
Using the Configuration Program
Before running the DOS Configuration and Diagnostic
Program, perform a clean DOS boot from a DOS diskette
(or the hard drive's DOS option, if provided) to ensure
that no memory managers or drivers are loaded. The
Configuration and Diagnostic Program does not run in
a DOS window called from another operating system.
To change the configuration option settings for the 3C359
NIC, follow these steps.
1 If you are using the 3.5-inch diskettes, insert
TokenDisk diskette #1 in the drive and make it
the active drive. For example, enter:
a:
If you are using the TokenDisk CD, insert it in the
CD-ROM drive and make that drive the active drive.
For example, enter:
d:
2 Enter:
3pcid
The DOS Diagnostic and Configuration Program screen
is displayed with the Test menu selected, as shown in
Figure B-1.
C
HANGING
C
ONFIGURATION
S
ETTINGS