Figure 32. Attach Printer Mechanism To Electronics Base - TransAct Epic 430 Maintenance Manual

Assembly and Disassembly

Figure 32. Attach Printer Mechanism to Electronics Base


Slide assembled printer mechanism into corresponding slots on
Electronics Base Frame, for OEM applications where base is mounted to
printer. Do this by aligning the tabs on one side of the printer mechanism
with the corresponding slots on the base, rotating the printer mechanism
into the base, then sliding the mechanism towards the rear of the base to
lock it into place.

Attach printer mechanism to front of Electronics Base Frame using two M3
Sems screws.
Page 66 43-06955 - Rev Q
Rotate printer
mechanism
counter-clockwise
into slots, then
slide towards rear
into place.